Quiz-summary
0 of 15 questions completed
Questions:
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
Information
NEC Code Practice Tests Quiz Questions Answers 10
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
Results
0 of 15 questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 points, (0)
Average score |
|
Your score |
|
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- Answered
- Review
-
Question 1 of 15
1. Question
1 pointsEquipment grounding conductors of the wire type must be sized based on the rating of the current overcurrent device:
Correct
Please Refer: NEC Code 250.122
Incorrect
Please Refer: NEC Code 250.122
-
Question 2 of 15
2. Question
1 pointsListed flexible metal conduit (FMC) can serve as an equipment grounding conductor where the circuit conductors are protected by an overcurrent device rated _______ or less:
Correct
Please Refer: NEC Code 250.118(5)(b)
Incorrect
Please Refer: NEC Code 250.118(5)(b)
-
Question 3 of 15
3. Question
1 pointsIf the rock bottom is encountered, the grounding rod must be driven at an angle not less than ______ degrees from the vertical:
Correct
Please Refer: NEC Code 250.53(G)
Incorrect
Please Refer: NEC Code 250.53(G)
-
Question 4 of 15
4. Question
1 pointsIf the water pipe or structural metal electrode is not available for grounding, a ground ring electrode encircling the building buried not less than 30 in. below grade, consisting of atleast _____ of bare copper conductors not smaller than 2 AWG can be used:
Correct
Please Refer: NEC Code 250.30(4) Exp-1
Incorrect
Please Refer: NEC Code 250.30(4) Exp-1
-
Question 5 of 15
5. Question
1 pointsOverheadĀ conductors must maintain a clearance of ______ from windows that open, doors, porches, balconies, ladders or similar structures:
Correct
Please Refer: NEC Code 225.19(D)(1)
Incorrect
Please Refer: NEC Code 225.19(D)(1)
-
Question 6 of 15
6. Question
1 pointsA listed and marked steel plate less than ________ thick that can be used where the 1 (1/4) in. space from the nearest edge cannot be maintained:
Correct
Please Refer: NEC Code 300.4(1)Exp-2
Incorrect
Please Refer: NEC Code 300.4(1)Exp-2
-
Question 7 of 15
7. Question
1 pointsWhen a single conductors are installed in a nonmettalic raceways, _________ of the metal enclosure must be minimized by cutting a slot between the individual holes through which the conductors pass:
Correct
Please Refer: NEC Code 300.20(B)
Incorrect
Please Refer: NEC Code 300.20(B)
-
Question 8 of 15
8. Question
1 pointsDistance between the raceways enclosing the same conductor must not be less than ______ times the trade size of the largest raceways, measured from the raceways nearest edge to nearest edge:
Correct
Please Refer: NEC Code 314.28(A)(2)
Incorrect
Please Refer: NEC Code 314.28(A)(2)
-
Question 9 of 15
9. Question
1 pointsAC cables run horizontally through steel or wood framing members is considered supported where such support does not exceed ______ :
Correct
Please Refer: NEC Code 320.30(C)
Incorrect
Please Refer: NEC Code 320.30(C)
-
Question 10 of 15
10. Question
1 pointsENT is permitted above a suspended ceiling if the suspended ceiling provides a ______ finish ratings:
Correct
Please Refer: NEC Code 362.10(5)
Incorrect
Please Refer: NEC Code 362.10(5)
-
Question 11 of 15
11. Question
1 pointsLocked Rotor Current (LRC) of motor is generally ______ times the full load ampere rating:
Correct
Please Refer: NEC Code 430.51
Incorrect
Please Refer: NEC Code 430.51
-
Question 12 of 15
12. Question
1 pointsBranch circuit conductors to a single motor compressor must have an ampacity not less than ______ of the motor compresser rated load or branch circuit selection current whichever is greater:
Correct
Please Refer: NEC Code 440.32
Incorrect
Please Refer: NEC Code 440.32
-
Question 13 of 15
13. Question
1 pointsDry type transformers ______ or less and not over 50 kVA can be installed above a suspended ceiling:
Correct
Please Refer: NEC Code 450.13(B)
Incorrect
Please Refer: NEC Code 450.13(B)
-
Question 14 of 15
14. Question
1 pointsA Class A GFCI opens the circuit when the current to ground has a value of _____ or higher:
Correct
Incorrect
-
Question 15 of 15
15. Question
1 points______ is the Overhead conductors between the utility electrical supply and the service point:
Correct
Please Refer: NEC Code 100
Incorrect
Please Refer: NEC Code 100