Quiz-summary
0 of 15 questions completed
Questions:
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
Information
NEC Code Practice Tests Quiz Questions Answers 16
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
Results
0 of 15 questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 points, (0)
Average score |
|
Your score |
|
Categories
- Not categorized 0%
-
Congrats, You Passed the Test
-
Sorry, You did not Pass
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- Answered
- Review
-
Question 1 of 15
1. Question
1 pointsUnderground service conductors can be as small as ______ for limited load applications:
Correct
Please Refer: NEC Code 230.31(B) Exp
Incorrect
Please Refer: NEC Code 230.31(B) Exp
-
Question 2 of 15
2. Question
1 pointsVertical clearance of overhead service conductors ______ shall be maintained over public streets, alleys and parking areas subjected to truck traffic:
Correct
Please Refer: NEC Code 230.34(B)(4)
Incorrect
Please Refer: NEC Code 230.34(B)(4)
-
Question 3 of 15
3. Question
1 pointsNeutral conductors _____ and smaller must be identified by a continuous gray outer finish:
Correct
Please Refer: NEC Code 200.6(A)(1)
Incorrect
Please Refer: NEC Code 200.6(A)(1)
-
Question 4 of 15
4. Question
1 pointsLamholders connected to a branch circuits rated over ______ must be of heavy-duty:
Correct
Please Refer: NEC Code 210.21
Incorrect
Please Refer: NEC Code 210.21
-
Question 5 of 15
5. Question
1 pointsIf the assembly and the overcurrent devices are both listed for operation at 100% of their rating, the branch circuit overcurrent device can be sized at ______ of the continuous load:
Correct
Please Refer: NEC Code 210.20(A)
Incorrect
Please Refer: NEC Code 210.20(A)
-
Question 6 of 15
6. Question
1 pointsA disconnecting means is required at poles that supports luminaires:
Correct
Please Refer: NEC Code 225.32 (Ex-3)
Incorrect
Please Refer: NEC Code 225.32 (Ex-3)
-
Question 7 of 15
7. Question
1 pointsA maximum of _____ disconnect switches or circuit breakers shall be mounted in a single enclosure:
Correct
Please Refer: NEC Code 225.33(A)
Incorrect
Please Refer: NEC Code 225.33(A)
-
Question 8 of 15
8. Question
1 pointsOverhead conductors spans must maintain vertical clearance of _____ over public streets, alleys, roads subject to truck traffic:
Correct
Please Refer: NEC Code 225.18(2)
Incorrect
Please Refer: NEC Code 225.18(2)
-
Question 9 of 15
9. Question
1 pointsIMC must be fastened within _____ of each outlet box, junction box, device box, cabinet, conduit body or other conduit termination:
Correct
Please Refer: NEC Code 342.30(A)(1)
Incorrect
Please Refer: NEC Code 342.30(A)(1)
-
Question 10 of 15
10. Question
1 pointsIf installed vertically, metal raceways must be securely supported at intervals not exceeding _____, with no more than one joint between supports:
Correct
Please Refer: NEC Code 376.30(B)
Incorrect
Please Refer: NEC Code 376.30(B)
-
Question 11 of 15
11. Question
1 pointsEMT must not be used in cinder concrete or cinder fill where subject to permanent moisture, unless encased in not less than ____ of concrete:
Correct
Please Refer: NEC Code 358.12(3)
Incorrect
Please Refer: NEC Code 358.12(3)
-
Question 12 of 15
12. Question
1 pointsThe _____ rating is the current in amperes the motor draws producing its rated horse-power load at its rated voltage, based on its efficiency and power factor:
Correct
Incorrect
-
Question 13 of 15
13. Question
1 pointsTrack lighting must not be installed less than ____ above the finished floor, except where protected from physical damage or where the track operates below 30V open circuit:
Correct
Please Refer: NEC Code 410.151(C)(8)
Incorrect
Please Refer: NEC Code 410.151(C)(8)
-
Question 14 of 15
14. Question
1 pointsAlternating Current general use snap switches can control Tungsten filament lamp loads not exceeding the ampere rating of the switch at _____:
Correct
Please Refer: NEC Code 404.14(A)(2)
Incorrect
Please Refer: NEC Code 404.14(A)(2)
-
Question 15 of 15
15. Question
1 pointsIn industrial establishments where the conditions of maintenance and supervision ensure that only qualified persons will service the installation, flexible cords or flexible cables not exceeding _____ can be installed in aboveground raceways:
Correct
Please Refer: NEC Code 400.14
Incorrect
Please Refer: NEC Code 400.14