Only those conductors on the ____ side of the service point connection are subject to the requirements of the NEC

The ____is a specific location where the supply conductors of the electric utility and the customer-owned (premises wiring) conductors connect

Underground service conductors from that point to the termination in the service equipment
they are termed as _____:

Service-entrance conductors used on circuits exceeding 600V nominal shall not be smaller than ___ unless in multiconductor cable

Multiconductor cable used as service entrance conductors in circuits exceeding 600V nominal shall not be smaller than ___

The isolating switch installed near to disconnecting means shall be accessible to ____:

An isolating switch with visible break contacts shall be installed on the ___ of the disconnecting means

Isolation Switch grounds the ___ conductors when they are disconnected from high voltage
line buses.

Service disconnecting means in systems rated over 600 volts may not be readily accessible if readily accessible operating mechanism or of an electronic switching devices are available

Fuses shall not be used as disconnecting means in circuits exceeding 600V nominal:

For providing short circuit protection, a fuse rated in continuous amperes not to exceed ___ times the ampacity of the conductor

Circuit breaker with a trip setting of not more than ___ times the ampacity of the conductors shall be considered as providing the required short-circuit protection.