Equipotential bonding is intended to increase voltage gradients in the area around a permanently installed pool or outdoor spa:

The parts of a permanently installed pool, outdoor spa, or outdoor hot tub must be bonded together with a solid copper conductor not smaller than _____ with listed pressure connectors

An equipotential bonding grid must extend _____ horizontally beyond the inside walls of a pool, outdoor spa, or outdoor hot tub

Bonding conductor for concrete pool, outer spa or outdoor hot tube shells must be secured within or under the perimeter surface _____ below the subgrade.

Where a double-insulated water pump motor is installed, a solid ____ copper conductor from the bonding grid must be provided for a replacement motor.

Bonding conductor for concrete pool must be ____ from the inside walls of the pool.

The electric motors, controllers, and wiring for an electrically operated cover must be located not less than _____ from the inside wall of a permanently installed pool

The electric motor and controller circuit used in hot bathtubs and SPAs must be ____ protected

Receptacles must not be located less than ___ from the inside walls of a storable pool

The emergency shutoff must be readily accessible to the users and located not less than ____ away, but adjacent to and within sight of the spa or hot tub.

At least one 15A or 20A, 125V receptacle must be located at least ____ from the inside wall of the spa or hot tub.

Luminaires and ceiling fans shall not be installed less than ______ above an indoor spa or hot tub where no GFCI protection is provided.